Make a Straw Rocket

Create a paper rocket that can be launched from a soda straw – then, modify the design to make the rocket fly farther!

Turn this into a lesson for students

Materials

 

Steps

Step 1 - Cut out and shape the rocket body

Carefully cut out the large rectangle on the rocket template. This will be the body of the rocket. Wrap the rocket body around a pencil length-wise and tape it closed to form a tube.

If you’re using a reusable metal straw, check that the diameter of the rocket body fits around the straw. If it’s too narrow, wrap the paper around the metal straw instead of the pencil. The rocket body should be loose enough that it slides off the straw, but not so loose that there are large gaps between the straw and paper.

Step 2 - Cut out and tape on the fins

Carefully cut out the two fin units. Line up the rectangle in the middle of the fin with the bottom of the rocket body and tape it to the rocket body. Nothing should stick out past the bottom of the rocket body.

Step 3 - Make a fin sandwich

Tape the other fin to the rocket body the same way as above, but on the other side, making a “fin sandwich.”

Step 4 -Bend the fins

Bend the part of each fin that looks like a triangle 90 degrees so that each fin is at a right angle to its neighbor. Looking from the bottom of the rocket, the fins should look like a +.

Step 5 - Make the nose cone

Twist and pinch the top of the rocket body around the tip of the pencil to create a “nose cone” for your rocket. Tape the nose cone to prevent air from escaping and to keep it from untwisting.

Step 6 - Measure the nose cone

Measure the nose cone from its base (right where it starts to narrow) to its tip and record the length in your data log and on the rocket itself.

Once completed, the rocket will be about 13 cm (about 5 inches) tall.

7. Prepare for launch

Remove the pencil and replace it with the soda straw.

8. Three, two, one … launch!

Be sure that your launch area is clear of people and other hazards. Mark your launch point with tape or an object. Then, blow into the straw to launch the rocket!

9. Measure the distance traveled

Use the meter stick or measuring tape to measure the distance your rocket traveled. Then, record the distance on your data log.

10. Improve your design

Can you make your rocket fly farther? Make new rockets by altering the template. Try different rocket lengths, fin shapes, fin sizes, or fin angles. Repeat steps 6 and 9 for every launch, recording each design change and distance in your data log. Make only one change at a time, so you will know which design changes result in changes in performance.

 

 Return to breakout sessions